Install Bathtub Drain Kit

Install Bathtub Drain Kit: A Step-by-Step Guide

Installing a bathtub drain kit is a relatively simple task that can be completed in just a few hours. By following these step-by-step instructions, you can ensure that your new drain is installed correctly and will provide years of trouble-free use.

Step 1: Gather Your Tools and Materials

Before you begin, you will need to gather the following tools and materials:

New bathtub drain kit
Adjustable wrench
Plumber's putty
Utility knife
Flashlight
Bucket
Rags

Step 2: Remove the Old Drain

Begin by placing a bucket under the bathtub drain to catch any water that may leak out. Using an adjustable wrench, loosen the nuts that hold the old drain in place. Once the nuts are loose, you can remove the old drain by hand.

Step 3: Clean the Drain Hole

Once the old drain is removed, use a utility knife to remove any old plumber's putty or sealant from the drain hole. Be careful not to scratch the bathtub surface.

Step 4: Apply New Plumber's Putty

Roll a rope of plumber's putty into a circle and place it around the base of the new drain. The putty should be thick enough to create a watertight seal, but not so thick that it oozes out when the drain is tightened.

Step 5: Install the New Drain

Place the new drain in the drain hole and hand-tighten the nuts until they are snug. Do not overtighten the nuts, as this could damage the drain or the bathtub.

Step 6: Test the Drain

Turn on the water and allow it to run into the bathtub. Check for any leaks around the drain. If you see any leaks, tighten the nuts until the leaks stop.

Step 7: Clean Up

Once the drain is installed and tested, use a rag to wipe away any excess plumber's putty or water. Your new bathtub drain is now installed and ready to use.