Remove Bathtub Stopper

A bathtub stopper is a small device that plugs the drain hole in a bathtub, preventing water from draining out. Bathtub stoppers can be made of various materials, including rubber, plastic, and metal. They come in different shapes and sizes to fit different types of drains.

Over time, bathtub stoppers can become clogged with hair, soap scum, and other debris. This can cause the stopper to not seal properly, allowing water to leak out of the bathtub. If the stopper is not removed and cleaned regularly, it can eventually become moldy or develop bacteria.

Removing a bathtub stopper is a simple task that can be done in a few minutes. Here are the steps on how to remove a bathtub stopper:

Materials You'll Need:

Needle-nose pliers
Flathead screwdriver
WD-40 or other penetrating oil

Instructions:

1. If the stopper is removable, it should have a small tab or lever that you can pull or push to release it. If there is no tab or lever, you will need to use needle-nose pliers to remove it.

2. Use the needle-nose pliers to grasp the stopper firmly and pull it straight up. If the stopper is stuck, you may need to wiggle it back and forth while pulling up on it.

3. Once the stopper is removed, inspect it for any clogs or debris. If there is any debris, use a flathead screwdriver or other sharp object to remove it.

4. If the stopper is still not sealing properly, you may need to apply some WD-40 or other penetrating oil to the o-ring seal. Allow the oil to sit for a few minutes, then reinsert the stopper and test it.

5. If the stopper is still not working properly, you may need to replace it. New bathtub stoppers are available at most hardware stores and home improvement centers.

Removing a bathtub stopper is a simple task that can be done in a few minutes. By following these steps, you can keep your bathtub draining properly and prevent leaks.