How To Take Out A Bathtub

How to Take Out a Bathtub

### Introduction Bathtubs can be a great addition to any bathroom, but they can also be a hassle to remove when it's time for a remodel. If you're planning to replace your bathtub, here's a step-by-step guide on how to remove it safely and easily. ### Safety First Before you begin, make sure you have all the necessary safety gear, including gloves, safety glasses, and a dust mask. Removing a bathtub can create a lot of dust and debris, so it's important to protect yourself. ### Disconnect the Plumbing The first step is to disconnect the plumbing that's connected to the bathtub. This includes the drain, the overflow drain, and the hot and cold water supply lines. Be careful not to damage the pipes when you're disconnecting them. ### Remove the Bathtub Surround Once the plumbing is disconnected, you can start removing the bathtub surround. This usually consists of tiles or panels that are attached to the wall around the bathtub. Use a pry bar or a putty knife to carefully remove the surround. ### Remove the Bathtub Once the surround is removed, you can start to remove the bathtub itself. This can be a challenging task, especially if the bathtub is heavy. It's best to have a helper or two to assist you. To remove the bathtub, start by detaching it from the wall studs. This is usually done with screws or nails. Once the bathtub is detached from the wall, you can carefully lift it out of the bathroom. ### Clean Up Once the bathtub is removed, you'll need to clean up the area. This includes sweeping or vacuuming up any debris, and wiping down the walls and floor. ### Repair the Floor If you're replacing the bathtub with a new one, you may need to repair the floor. This could involve patching any holes or cracks, or leveling the floor if it's uneven. ### Install the New Bathtub Once the floor is repaired, you can install the new bathtub. This is usually done by following the manufacturer's instructions. ### Reconnect the Plumbing Once the new bathtub is installed, you can reconnect the plumbing. Be sure to test the plumbing to make sure there are no leaks. ### Finish the Installation Once the plumbing is reconnected, you can finish the installation by adding the bathtub surround and any other fixtures you desire. ### Conclusion Removing a bathtub can be a challenging task, but it's definitely doable with the right tools and a little bit of patience. By following these steps, you can safely and easily remove your old bathtub and install a new one.