How To Replace Push Bathtub Stopper

A push bathtub stopper is a simple but essential part of any bathroom. It allows you to fill the tub with water and then stop the flow when you're finished. Over time, however, push bathtub stoppers can become worn or damaged, and they may need to be replaced. If you're not sure how to replace a push bathtub stopper, don't worry - it's actually a very easy process. Here's a step-by-step guide:

Step 1: Remove the old stopper.

To remove the old stopper, simply pull it up from the drain hole. If the stopper is stuck, you can use a pair of pliers to gently pry it loose. Once the stopper is removed, you will see a rubber washer underneath it. This washer creates a seal between the stopper and the drain hole, so it's important to make sure that it is in good condition. If the washer is worn or damaged, you should replace it with a new one.

Step 2: Clean the drain hole.

Once the old stopper is removed, take a moment to clean the drain hole. You can use a sponge or a brush to remove any hair, soap scum, or other debris that may have accumulated. This will help to ensure that the new stopper fits properly and creates a good seal.

Step 3: Insert the new stopper.

To insert the new stopper, simply push it down into the drain hole. The stopper should fit snugly into the hole, and the rubber washer should create a seal around the edges. If the stopper is not fitting properly, you may need to adjust the rubber washer.

Step 4: Test the stopper.

Once the stopper is inserted, test it to make sure that it is working properly. Fill the tub with water and then press down on the stopper. The water should stop flowing immediately. If the water continues to flow, you may need to adjust the stopper or replace the rubber washer.

Step 5: Enjoy your new stopper!

Replacing a push bathtub stopper is a quick and easy process. By following these simple steps, you can ensure that your bathtub stopper is working properly and that you can enjoy a relaxing bath without any leaks.