How To Replace Bathtub Spout With Diverter

How to Effortlessly Replace a Bathtub Spout with a Diverter

Refreshing your bathroom with a new tub spout and diverter can elevate both its functionality and aesthetics. Fortunately, this DIY project is surprisingly straightforward, requiring minimal tools and effort. Embark on this step-by-step guide to master the process and create a revitalized bathroom space.

Materials and Tools:

* New bathtub spout with diverter * Adjustable wrench or basin wrench * Plumber's putty * Teflon tape (optional) * Utility knife (for cutting putty)

Step-by-Step Instructions:

1. Shut Off Water Supply and Drain Bathtub Begin by ensuring the water supply to your bathtub is completely turned off. Locate the shutoff valves beneath the sink or behind the access panel, and close them tightly. Allow the bathtub to drain thoroughly. 2. Remove the Old Spout Using an adjustable wrench or basin wrench, loosen the locknut connecting the old spout to the wall unit. Turn it counterclockwise while applying gentle pressure. Once the locknut is loose, lift the old spout away from the wall unit. 3. Clean the Wall Unit Thoroughly clean the threads on the wall unit where the new spout will be installed. Remove any leftover plumber's putty or debris using a damp cloth. 4. Apply Plumber's Putty Roll a small amount of plumber's putty into a thin rope and wrap it around the threads of the new spout. Avoid over-applying the putty, as excess can interfere with the spout's seal. 5. Install the New Spout Carefully align the new spout with the wall unit and screw it on by hand as far as possible. Tighten it further using the adjustable wrench, ensuring it is snugly attached but not over-tightened. 6. Optional: Use Teflon Tape For added tightness, wrap a layer of Teflon tape around the threads of the diverter before screwing it onto the spout. This step helps prevent water leaks. 7. Install the Diverter Thread the diverter onto the spout and hand-tighten it. Use the adjustable wrench to complete the tightening process. 8. Turn On Water Supply and Test Once everything is securely in place, turn on the water supply and check for any leaks around the spout or diverter. If a leak occurs, tighten the appropriate connection points further. 9. Enjoy Your Upgraded Bathtub Congratulations! You have successfully replaced your bathtub spout with diverter. Enjoy the enhanced functionality and refreshed look of your bathroom.