How To Replace Bathtub Fixtures

How to Replace Bathtub Fixtures

Bathtub fixtures are an essential part of any bathroom, and they can make a big difference in the overall look and feel of the space. If your bathtub fixtures are old, worn out, or simply not to your taste, replacing them is a relatively easy and affordable project that you can do yourself. ### Tools and Materials Before you begin, you'll need to gather the following tools and materials: * Adjustable wrench * Phillips head screwdriver * Flat head screwdriver * Putty knife * Plumber's putty * Teflon tape * New bathtub fixtures * Safety goggles ### Step-by-Step Guide 1.

Turn Off the Water Supply:

Before you start working on the fixtures, turn off the water supply to the bathtub. This will prevent any leaks or water damage while you're working. 2.

Remove the Old Fixtures:

Use the adjustable wrench to loosen the nuts that hold the old fixtures in place. Once the nuts are loose, you can remove the old fixtures by hand. 3.

Clean the Bathtub Surface:

Use the putty knife to scrape away any old putty or sealant from the bathtub surface. Then, use a damp cloth to clean the surface of the bathtub. 4.

Apply Plumber's Putty:

Apply a thin bead of plumber's putty around the base of the new fixtures. This will help to seal the fixtures and prevent leaks. 5.

Install the New Fixtures:

Place the new fixtures in the desired location on the bathtub. Use the adjustable wrench to tighten the nuts that hold the fixtures in place. 6.

Wrap the Pipe Threads with Teflon Tape:

Wrap the threads of the water supply pipes with Teflon tape. This will help to prevent leaks. 7.

Connect the Water Supply Lines:

Connect the water supply lines to the new fixtures. Be sure to tighten the connections securely. 8.

Turn On the Water Supply:

Turn on the water supply to the bathtub and check for leaks. If there are any leaks, tighten the connections until the leaks stop. 9.

Test the Fixtures:

Turn on the bathtub faucet and showerhead and check to make sure that they're working properly. Adjust the water temperature and flow as desired. ### Troubleshooting If you run into any problems while replacing your bathtub fixtures, here are a few troubleshooting tips: *

Leaks:

If you have leaks around the fixtures, try tightening the connections. If that doesn't work, you may need to apply more plumber's putty. *

Low Water Pressure:

If you have low water pressure after replacing the fixtures, check to make sure that the water supply lines are not kinked or blocked. You may also need to adjust the water pressure regulator on your water heater. *

Noise:

If you hear a noise when you turn on the water, it's possible that there's air in the pipes. Try running the water for a few minutes to see if the noise goes away. If it doesn't, you may need to bleed the air from the pipes. ### Conclusion Replacing bathtub fixtures is a relatively easy and affordable project that you can do yourself. By following these steps, you can update the look of your bathroom and enjoy new, functional fixtures for years to come.