How To Replace A Broken Bathtub Faucet Handle

How to Replace a Broken Bathtub Faucet Handle

A broken bathtub faucet handle can be a nuisance, but it's not difficult to replace. With a few basic tools and a little know-how, you can have your faucet working again in no time.

Here's what you'll need:

Replacement faucet handle
Phillips screwdriver
Adjustable wrench
Pliers
Cloth or towel

Once you have your tools, follow these steps:

Turn off the water supply. There will be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise until they are fully closed.
Remove the old handle. Use a Phillips screwdriver to remove the screws that are holding the handle in place. Once the screws are removed, pull the handle straight up to remove it.
Remove the cartridge. The cartridge is the part of the faucet that controls the flow of water. To remove the cartridge, use pliers to unscrew the retaining nut that is located behind the handle. Once the nut is loose, pull the cartridge straight out of the faucet body.
Install the new cartridge. Insert the new cartridge into the faucet body and tighten the retaining nut with pliers.
Install the new handle. Align the new handle with the cartridge and push it down until it clicks into place. Tighten the screws that hold the handle in place with a Phillips screwdriver.
Turn on the water supply. Open the shut-off valves under the sink to turn the water supply back on.
Check for leaks. Use a cloth or towel to wipe around the base of the faucet and check for any leaks. If you see any leaks, tighten the retaining nut or the screws that hold the handle in place until the leak stops.

Replacing a bathtub faucet handle is a relatively easy task that can be completed in a few minutes. By following these steps, you can save yourself the cost of calling a plumber.