How To Replace A Bathtub Liner

How to Replace a Bathtub Liner: A Step-by-Step Guide

Replacing a bathtub liner is a project that can be completed in a few hours with the right tools and materials. While it's not a complex task, it does require some attention to detail to ensure a watertight seal. Here's a step-by-step guide on how to replace a bathtub liner:

Materials Needed:

New bathtub liner
Tub and tile caulk
Utility knife
Measuring tape
Level
Caulk gun

Step 1: Remove the Old Liner

Start by removing the old bathtub liner. Use a utility knife to carefully cut around the edges of the liner, where it meets the tub and tile. Once you've cut around the entire perimeter, carefully peel the liner away from the tub.

Step 2: Clean the Bathtub

Once the old liner is removed, thoroughly clean the bathtub with a mild cleanser. Remove any dirt, soap scum, or mildew that may have accumulated. This will ensure that the new liner adheres properly.

Step 3: Install the New Liner

Place the new bathtub liner in the tub and center it. Use a level to ensure that the liner is installed evenly. Once you're satisfied with the placement, press down firmly on the edges of the liner to secure it in place.

Step 4: Caulk the Edges

Apply a bead of tub and tile caulk around the edges of the liner, where it meets the tub and tile. Use a caulk gun to ensure a smooth, even bead. Smooth the caulk with your finger or a caulk tool.

Step 5: Allow the Caulk to Dry

Allow the caulk to dry completely before using the bathtub. The drying time will vary depending on the type of caulk you used. Refer to the manufacturer's instructions for specific drying times.