How To Remove Stuck Bathtub Drain Stopper From Tubeless

How to Remove Stuck Bathtub Drain Stopper from Tubeless

A stuck bathtub drain stopper can be a major inconvenience, and if you don't have the right tools or know-how, it can be difficult to remove. However, with a few simple steps, you can easily remove the stopper and get your drain flowing again.

Gather Your Tools

Before you begin, gather the following tools:

Pliers
Screwdriver
Allen wrench
Toothbrush
Vinegar

Step 1: Remove the Overflow Plate

Most bathtubs have an overflow plate that covers the overflow hole. Use a screwdriver or Allen wrench to remove the screws that hold the plate in place. Once the screws are removed, gently pull the plate off.

Step 2: Loosen the Stopper

Once the overflow plate is removed, you will see the drain stopper. Use pliers to gently loosen the stopper. If the stopper is really stuck, you may need to apply some penetrating oil to help loosen it up.

Step 3: Remove the Stopper

Once the stopper is loose, you can remove it by hand. If the stopper is still stuck, use a toothbrush to gently scrub around the edges. This will help to remove any debris or gunk that may be holding the stopper in place.

Step 4: Clean the Drain

Once the stopper is removed, take this opportunity to clean the drain. Use a toothbrush to scrub around the edges of the drain and remove any hair or debris that may have accumulated.

Step 5: Reinstall the Stopper

Once the drain is clean, you can reinstall the stopper. Simply insert the stopper into the drain and tighten it by hand. If the stopper is not tight enough, it may leak. If the stopper is too tight, it may be difficult to remove in the future.

Tips

Here are a few tips to help you remove a stuck bathtub drain stopper:

If the stopper is really stuck, you can try soaking it in vinegar for a few hours. This will help to dissolve any mineral deposits that may be holding the stopper in place.
If you don't have any pliers, you can use a pair of vice grips to loosen the stopper.
Be careful not to overtighten the stopper when you reinstall it.