How to Remove a Bathtub Stopper Pop Up
A bathtub stopper pop up is a device that allows you to plug or unplug the drain of your bathtub. It is usually made of rubber or plastic and is attached to a metal rod that runs through the drain hole. The pop up stopper is held in place by a spring, which allows it to be pushed down to close the drain or pulled up to open it.
There are times when you may need to remove the pop up stopper from your bathtub. For example, you may need to clean it if it becomes clogged with hair or soap scum. You may also need to replace it if it becomes damaged or worn out.
Removing a bathtub pop up stopper is not a difficult task. However, it is important to follow the steps carefully to avoid damaging the stopper or the bathtub.
Materials:
- Phillips screwdriver
- Adjustable wrench
- Pliers
Steps:
- Turn off the water supply to the bathtub. This is usually done by turning off the valve under the sink.
- Remove the overflow plate. The overflow plate is the small, round plate located near the top of the bathtub. It is usually held in place by a few screws. Use a Phillips screwdriver to remove the screws and then lift off the overflow plate.
- Locate the pop up stopper assembly. The pop up stopper assembly is located behind the overflow plate. It consists of a metal rod, a spring, and the pop up stopper.
- Disconnect the pop up stopper from the metal rod. There is usually a small clip that holds the pop up stopper to the metal rod. Use pliers to remove the clip and then pull the pop up stopper off the rod.
- Remove the metal rod from the bathtub. The metal rod is usually held in place by a nut. Use an adjustable wrench to loosen the nut and then pull the rod out of the bathtub.
- Clean or replace the pop up stopper. If the pop up stopper is clogged, you can clean it with a mild detergent and water. If the pop up stopper is damaged, you will need to replace it.
- Reassemble the pop up stopper assembly. Reverse the steps above to reassemble the pop up stopper assembly.
- Reinstall the overflow plate. Replace the overflow plate over the pop up stopper assembly and secure it with the screws.
- Turn on the water supply to the bathtub. Test the pop up stopper to make sure that it is working properly.
How To Remove Pop Up Tub Stopper Easy Method
How To Remove A Bathtub Drain Stopper
Bathroom Repair How To A Pop Up Tub Drain Stopper
How To Remove A Bathtub Drain The Home Depot
Remove Pop Up Bath Tub Drain Stopper 3 Ways
How To Remove A Bathtub Drain Stopper
How To Remove Any Bathtub Stopper Pop Up Grate Or Plug
How To Remove A Pop Up Tub Drain Plug Stopper Easy No Tools Needed
How To Remove A Bathtub Drain Stopper
How To Remove A Bathtub Drain Forbes Home
