How To Remove Bathtub Drain

How to Remove a Bathtub Drain

A bathtub drain is an essential part of any bathroom, allowing water to drain from the tub and preventing it from overflowing. Over time, bathtub drains can become clogged with hair, soap scum, and other debris, which can lead to slow drainage or even a complete blockage. If you're experiencing problems with your bathtub drain, you may need to remove it to clean it or replace it. ### Steps to Remove a Bathtub Drain 1.

Gather Your Tools

Before you begin, you'll need to gather a few tools: * Adjustable wrench * Plumber's putty knife * Screwdriver * Bucket * Rags * Safety goggles * Gloves 2.

Prepare the Area

Start by turning off the water supply to the bathtub. This is usually done by turning the valve located under the sink or behind the toilet. Once the water is turned off, open the bathtub drain to allow any remaining water to drain out. 3.

Remove the Overflow Plate

The overflow plate is the small, round plate located near the top of the bathtub. It's usually held in place by a few screws. Use a screwdriver to remove the screws, then lift off the overflow plate. 4.

Remove the Drain Stopper

The drain stopper is the part of the drain that opens and closes to allow water to flow in and out of the tub. It's usually held in place by a small screw or by a locking mechanism. If there's a screw, use a screwdriver to remove it. If there's a locking mechanism, twist or press it to release the stopper. 5.

Remove the Drain Assembly

The drain assembly is the part of the drain that's located inside the tub. It's usually held in place by a few screws or nuts. Use an adjustable wrench to loosen the screws or nuts, then lift out the drain assembly. 6.

Clean the Drain Assembly

Once you've removed the drain assembly, take it to a sink or outside and clean it thoroughly. Use a plumber's putty knife to scrape off any hair, soap scum, or other debris. You can also use a mild detergent and a brush to clean the drain assembly. 7.

Reinstall the Drain Assembly

Once the drain assembly is clean, reinsert it into the bathtub drain. Hand-tighten the screws or nuts until the drain assembly is secure. 8.

Reinstall the Drain Stopper

Reinstall the drain stopper by inserting it into the drain assembly and tightening the screw or locking mechanism. 9.

Reinstall the Overflow Plate

Reinstall the overflow plate by replacing the screws and tightening them until the plate is secure. 10.

Turn on the Water Supply

Turn on the water supply to the bathtub and check for leaks. If you see any leaks, tighten the screws or nuts until the leaks stop. ### Safety Tips * Always wear safety goggles and gloves when working on a bathtub drain. * If you're not comfortable working with plumbing, you can call a professional plumber to remove the drain for you. * If the drain is badly damaged, you may need to replace it with a new one.