How To Remove And Install A Bathtub

How to Remove and Install a Bathtub

Replacing a bathtub can be a daunting task, but it's definitely doable with the right tools and a little bit of know-how. Here's a step-by-step guide to help you get the job done:

Removing the Old Bathtub

1. Turn off the water supply

The first step is to turn off the water supply to the bathtub. There should be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to shut off the water.

2. Disconnect the drain and overflow

Once the water is turned off, you can disconnect the drain and overflow. The drain is usually held in place by a nut that you can unscrew by hand. The overflow is usually held in place by a few screws.

3. Remove the bathtub surround

The bathtub surround is the material that surrounds the bathtub, such as tile or fiberglass. To remove the surround, you will need to use a utility knife to cut the caulk around the edges. Once the caulk is cut, you can pry the surround away from the bathtub.

4. Disconnect the plumbing

Once the surround is removed, you can disconnect the plumbing from the bathtub. The plumbing is usually connected to the bathtub by a few nuts and bolts. You will need to use a wrench to loosen the nuts and bolts.

5. Lift the bathtub out of place

Once the plumbing is disconnected, you can lift the bathtub out of place. Be careful not to damage the bathtub or the floor when you are lifting it out.

Installing the New Bathtub

1. Set the new bathtub in place

The first step is to set the new bathtub in place. Make sure that the bathtub is level and that it is properly supported by the floor.

2. Connect the plumbing

Once the bathtub is in place, you can connect the plumbing. The plumbing is usually connected to the bathtub by a few nuts and bolts. You will need to use a wrench to tighten the nuts and bolts.

3. Install the bathtub surround

The bathtub surround is the material that surrounds the bathtub, such as tile or fiberglass. To install the surround, you will need to apply a bead of caulk around the edges of the bathtub. Then, you can press the surround into place.

4. Reconnect the drain and overflow

Once the surround is installed, you can reconnect the drain and overflow. The drain is usually held in place by a nut that you can tighten by hand. The overflow is usually held in place by a few screws.

5. Turn on the water supply

Once the drain and overflow are reconnected, you can turn on the water supply. Check for any leaks and make any necessary adjustments. That's it! You have now successfully removed and installed a bathtub.