How To Remove A Lift And Turn Bathtub Drain Stopper

How to Remove a Lift and Turn Bathtub Drain Stopper

A lift and turn bathtub drain stopper is a common type of drain stopper that is found in many homes. It is a simple device that consists of a stopper that is attached to a chain. The stopper is lifted and turned to open and close the drain. Over time, these stoppers can become clogged with hair, soap scum, and other debris. This can make it difficult to open and close the stopper, and it can also lead to leaks. If your lift and turn bathtub drain stopper is not working properly, you can try to remove it and clean it.

Here are the steps on how to remove a lift and turn bathtub drain stopper:

Gather your tools. You will need a pair of pliers, a screwdriver, and a bucket.
Remove the overflow plate. The overflow plate is the small, round plate that is located on the side of the bathtub. It is held in place by a few screws. Use the screwdriver to remove the screws and then lift off the overflow plate.
Locate the stopper. The stopper is located at the bottom of the drain. It is attached to a chain that is connected to the overflow plate.
Remove the chain. Use the pliers to remove the chain from the stopper. Be careful not to break the chain.
Lift out the stopper. Once the chain is removed, you can lift out the stopper. Be careful not to drop it into the drain.
Clean the stopper. Once the stopper is removed, you can clean it with soap and water. You can also use a toothbrush to remove any stubborn debris.
Reassemble the drain stopper. Once the stopper is clean, you can reassemble the drain stopper. Start by attaching the chain to the stopper. Then, insert the stopper into the drain and screw on the overflow plate.