How To Install Faucet In Bathtub

How to Install a Faucet in a Bathtub

Installing a faucet in a bathtub is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can ensure a successful installation.

Materials:

New bathtub faucet
Wrench
Plumber's putty
Teflon tape

Step 1: Turn off the water supply

Before you begin, it is important to turn off the water supply to the bathtub. Locate the shutoff valves under the sink or behind the bathtub and turn them clockwise to close them.

Step 2: Remove the old faucet

Once the water supply is turned off, you can remove the old faucet. Use a wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet straight up to remove it.

Step 3: Apply plumber's putty

Before you install the new faucet, you need to apply plumber's putty to the base of the faucet. Plumber's putty is a pliable sealant that will help to create a watertight seal between the faucet and the bathtub.

To apply plumber's putty, roll it into a rope and then press it around the base of the faucet. Make sure that the putty is evenly distributed and that there are no gaps.

Step 4: Install the new faucet

Once the plumber's putty is in place, you can install the new faucet. Align the faucet with the holes in the bathtub and then push it down into place. Once the faucet is in place, tighten the nuts that hold it in place.

Step 5: Wrap Teflon tape around the threads

Before you connect the water supply lines to the faucet, you need to wrap Teflon tape around the threads. Teflon tape helps to create a watertight seal and prevent leaks.

To wrap Teflon tape, simply start at the end of the thread and wrap it around the thread in a clockwise direction. Make sure that the tape is evenly distributed and that there are no gaps.

Step 6: Connect the water supply lines

Once the Teflon tape is in place, you can connect the water supply lines to the faucet. Hand-tighten the nuts that hold the water supply lines in place and then use a wrench to tighten them further.

Step 7: Turn on the water supply

Once the water supply lines are connected, you can turn on the water supply. Check for leaks around the faucet and water supply lines. If there are any leaks, tighten the nuts until the leaks stop.

Congratulations! You have now successfully installed a faucet in your bathtub.