How To Fix Chip In Bathtub

How to Fix a Chip in a Bathtub

A chipped bathtub can be an eyesore and a potential hazard. The rough edges can snag on skin or clothing, and if the chip is deep enough, it can leak water.

Fortunately, fixing a chip in a bathtub is a relatively easy and inexpensive DIY project. With the right materials and a little bit of elbow grease, you can repair the chip and restore your bathtub to its original condition.

Materials you will need:

Epoxy repair kit
Sandpaper (fine-grit and medium-grit)
Microfiber cloth
Rubbing alcohol
Painter's tape (optional)

Steps:

1. Clean the area around the chip

Use a microfiber cloth dampened with rubbing alcohol to clean the area around the chip. This will remove any dirt or debris that could interfere with the bond of the epoxy.

2. Sand the edges of the chip

Use fine-grit sandpaper to sand the edges of the chip. This will create a rough surface that the epoxy can adhere to.

3. Mix the epoxy

Follow the instructions on the epoxy repair kit to mix the epoxy. Be sure to mix the epoxy thoroughly until it is a uniform color.

4. Apply the epoxy to the chip

Use a putty knife or a Popsicle stick to apply the epoxy to the chip. Fill the chip completely and smooth the surface with your finger or a wet sponge.

5. Tape the area (optional)

If you are concerned about the epoxy spreading beyond the edges of the chip, you can apply painter's tape around the perimeter of the chip. This will help to keep the epoxy in place while it dries.

6. Let the epoxy dry

Allow the epoxy to dry for the amount of time specified on the epoxy repair kit. Most epoxies will take several hours to dry completely.

7. Sand the repaired area

Once the epoxy is dry, use medium-grit sandpaper to sand the repaired area. Sand until the surface is smooth and even with the surrounding bathtub.

8. Clean the area

Use a microfiber cloth dampened with rubbing alcohol to clean the repaired area. This will remove any dust or debris.

Your bathtub is now repaired and ready to use.