How To Fix Bathtub Stopper

How To Fix Bathtub Stopper: The Ultimate Guide ##

A faulty bathtub stopper can be a major inconvenience, making it difficult to fill the tub for a bath or causing unwanted leaks. Fixing a bathtub stopper is a relatively simple task that can be accomplished with just a few tools and materials. Follow these step-by-step instructions to get your bathtub stopper back in working order: ### 1. Gather the necessary tools and materials: ### * Adjustable wrench * Pliers * Screwdriver * Rags * Bucket * Old toothbrush * Baking soda * Vinegar * Petroleum jelly ### 2. Prepare the bathtub: ### * Turn off the water supply to the bathtub. * Open the drain to allow any remaining water to drain out. * Place a bucket or container under the drain to catch any water or debris that may fall during the repair process. ### 3. Remove the old stopper: ### * Locate the overflow plate, which is typically found near the top of the bathtub wall. * Use the adjustable wrench to loosen the overflow plate and remove it from the bathtub. * Reach into the overflow hole and locate the stopper assembly. * Use the pliers to grasp the stopper assembly and pull it out of the bathtub. ### 4. Clean the stopper assembly: ### * Soak the stopper assembly in a mixture of baking soda and vinegar for approximately 30 minutes. * Use an old toothbrush to scrub away any dirt, grime, or mineral deposits that have accumulated on the stopper. * Rinse the stopper assembly thoroughly with water and dry it with a rag. ### 5. Inspect the stopper assembly for damage: ### * Look for any cracks, breaks, or other signs of damage to the stopper assembly. * If the stopper assembly is damaged, it will need to be replaced. ### 6. Lubricate the stopper assembly: ### * Apply a thin coat of petroleum jelly to the threads of the stopper assembly. * This will help to prevent the stopper from sticking and will make it easier to operate. ### 7. Reinstall the stopper assembly: ### * Insert the stopper assembly into the overflow hole. * Use the pliers to tighten the stopper assembly until it is snug. * Replace the overflow plate and tighten it with the adjustable wrench. ### 8. Test the stopper: ### * Turn on the water supply to the bathtub and fill the tub with water. * Check the stopper to make sure that it is properly sealing the drain. * If the stopper is leaking, adjust it until it is properly sealed. ### 9. Enjoy your newly fixed bathtub stopper! ### With these simple steps, you can easily fix a faulty bathtub stopper and restore your bathtub to proper working order.