How To Fill In A Sunken Bathtub

How to Fill In a Sunken Bathtub

A sunken bathtub can be an eyesore and a safety hazard. If you're dealing with a sunken tub, don't worry - it's a relatively easy fix that you can do yourself with a few tools and materials.

Here's a step-by-step guide on how to fill in a sunken bathtub:

Step 1: Safety First

Before you begin, turn off the water supply to the bathtub and drain any remaining water. Then, put on safety glasses and gloves to protect yourself from debris and chemicals.

Step 2: Remove the Bathtub Surround

The bathtub surround is the trim that goes around the edges of the tub. It's usually made of tile, plastic, or fiberglass. To remove the surround, use a utility knife to cut through the caulk around the edges. Then, carefully pry the surround away from the tub.

Step 3: Inspect the Bathtub

Once the surround is removed, you'll be able to see the condition of the bathtub. If the tub is cracked or damaged, you'll need to replace it. However, if the tub is in good condition, you can proceed to the next step.

Step 4: Level the Bathtub

Use a level to check if the bathtub is level. If it's not, you'll need to shim it up with shims. Shims are small, wedge-shaped pieces of wood or plastic that you can insert under the tub to level it out.

Step 5: Fill in the Gap

Once the bathtub is level, you can fill in the gap between the tub and the floor. To do this, use a non-expanding foam sealant. Apply the sealant around the edges of the tub, making sure to fill in any gaps. Allow the sealant to dry completely according to the manufacturer's instructions.

Step 6: Reinstall the Bathtub Surround

Once the sealant is dry, you can reinstall the bathtub surround. Apply a bead of caulk around the edges of the tub, then press the surround into place. Use a wet rag to smooth out the caulk and remove any excess.