Bathtub Drain Stop

Bathtub Drain Stop: A Comprehensive Guide

A bathtub drain stop is a small device that fits into the drain hole of a bathtub to prevent water from flowing out. It is a simple but essential part of any bathroom, and it can help to save water and energy. ### Types of Bathtub Drain Stops There are two main types of bathtub drain stops: *

Lift-and-turn drain stops:

These are the most common type of drain stop. They have a small lever that you lift to open the drain, and then turn to close it. *

Push-and-pull drain stops:

These drain stops have a plunger that you push down to open the drain, and then pull up to close it. Both types of drain stops are easy to use, but lift-and-turn drain stops are generally considered to be more durable. ### How to Install a Bathtub Drain Stop Installing a bathtub drain stop is a relatively easy task. Here are the steps: 1.

Remove the old drain stop.

If there is an old drain stop in place, you will need to remove it before you can install the new one. To do this, simply unscrew the drain stop from the drain hole. 2.

Clean the drain hole.

Once the old drain stop is removed, you should clean the drain hole to remove any dirt or debris. You can do this with a sponge or a brush. 3.

Apply plumber's putty to the new drain stop.

Plumber's putty is a type of sealant that helps to keep water from leaking out of the drain hole. To apply plumber's putty, simply roll it into a rope and then wrap it around the base of the new drain stop. 4.

Screw the new drain stop into the drain hole.

Once you have applied plumber's putty to the new drain stop, you can screw it into the drain hole. Be sure to tighten the drain stop until it is snug. 5.

Test the drain stop.

Once the new drain stop is installed, you should test it to make sure that it is working properly. To do this, simply fill the bathtub with water and then close the drain stop. The water should stop flowing out of the drain hole. ### Troubleshooting Bathtub Drain Stops If your bathtub drain stop is not working properly, there are a few things you can check: *

Is the drain stop properly installed?

Make sure that the drain stop is screwed in tightly and that there is no plumber's putty leaking out from around the base. *

Is the drain hole clean?

If the drain hole is clogged with dirt or debris, the drain stop may not be able to seal properly. Clean the drain hole with a sponge or a brush. *

Is the drain stop damaged?

If the drain stop is damaged, it may not be able to seal properly. Inspect the drain stop for any cracks or breaks. If you have tried all of these things and the drain stop is still not working properly, you may need to call a plumber. ### Conclusion A bathtub drain stop is a small but essential part of any bathroom. By following the steps in this article, you can easily install and troubleshoot a bathtub drain stop.

The 7 Common Types Of Bathtub Drain Stoppers

Danco 2 In Plastic Touch Toe Bathtub Drain Stopper Chrome 80811 The Home Depot

Danco Lift And Turn Tub Drain Stopper In Chrome 88599 The Home Depot

How To Remove A Bathtub Drain Stopper

Bath Tub Drain Stopper Gray Oxo Target

Bathtub Drain Stopper Rubber True Value

Danco Multi Fit Touch Toe Bathtub Drain Stopper In Brushed Nickel The Shower Accessories Department At Com

Drain Buddy Tub Stopper And Hair Catcher Solutions

4 Easy Ways To Remove A Tub Drain Stopper Wikihow

How To Replace Bathtub Drain Stopper With A Lift And Turn Diy