Kohler Lift And Turn Bathtub Drain Stopper Installation

Kohler Lift And Turn Bathtub Drain Stopper Installation: A Comprehensive Guide

Replacing a bathtub drain stopper can seem like a daunting task, but it's actually quite simple with the right tools and a little bit of guidance. In this article, we'll walk you through the essential aspects of installing a Kohler lift and turn bathtub drain stopper, from preparing your materials to testing your new stopper.

Step 1: Gather Your Materials

Before you begin, make sure you have all the necessary materials on hand. You'll need:

A new Kohler lift and turn bathtub drain stopper

A pair of pliers

A screwdriver

A putty knife

Plumber's putty

Step 2: Remove the Old Drain Stopper

Start by turning off the water supply to your bathtub. Once the water is turned off, you can use a pair of pliers to unscrew the old drain stopper. Be careful not to overtighten the pliers, as you could damage the stopper or the bathtub.

Step 3: Clean the Drain Hole

Once the old drain stopper is removed, you'll need to clean the drain hole. Use a putty knife to scrape away any old caulk or debris. You can also use a damp cloth to wipe away any dirt or grime.

Step 4: Apply Plumber's Putty

Next, you'll need to apply plumber's putty to the new drain stopper. Pinch off a small piece of putty and roll it into a snake-like shape. Wrap the putty around the base of the stopper, making sure to cover all the threads.

Step 5: Install the New Drain Stopper

Now you're ready to install the new drain stopper. Carefully insert the stopper into the drain hole, making sure to align the threads with the hole. Turn the stopper clockwise until it's hand-tight. Then, use a screwdriver to tighten the stopper an additional 1/4 turn.

Step 6: Test the Drain Stopper

Once the drain stopper is installed, it's important to test it to make sure it's working properly. Turn on the water and let it run for a few minutes. The water should drain out of the tub without overflowing. If the water is not draining properly, you may need to adjust the stopper or reapply plumber's putty.

Conclusion

Installing a Kohler lift and turn bathtub drain stopper is a relatively simple task that can be completed in just a few minutes. By following the steps outlined in this article, you can save yourself the time and expense of calling a plumber.