How To Install Bathtub And Wall Surround

If you're looking to upgrade your bathroom, installing a new bathtub and wall surround is a great way to give it a fresh, new look. While it may seem like a daunting task, it's actually relatively easy to do yourself with the right tools and materials.

In this article, we'll walk you through the steps on how to install a bathtub and wall surround. We'll also provide some tips and tricks to help you get the job done right.

Materials You'll Need

New bathtub
New wall surround
Cement board
Thin-set mortar
Grout
Caulk

Tools You'll Need

Circular saw
Jigsaw
Drill
Level
Tape measure
Putty knife
Grout float

Step-by-Step Instructions

1. Remove the Old Bathtub and Wall Surround

The first step is to remove the old bathtub and wall surround. To do this, you'll need to disconnect the plumbing and electrical connections. Once the old bathtub and wall surround are removed, you'll need to clean the area thoroughly.

2. Install the Cement Board

Next, you'll need to install the cement board. Cement board is a backer board that provides a smooth, flat surface for the tile to be installed on. To install the cement board, you'll need to cut it to size and then attach it to the wall studs using screws.

3. Thin-Set the Wall Surround

Once the cement board is installed, you'll need to thin-set the wall surround. Thin-set is a type of mortar that is used to adhere tile to a backing board. To thin-set the wall surround, you'll need to mix the thin-set according to the manufacturer's instructions and then apply it to the cement board using a trowel.

4. Install the Wall Surround

Once the thin-set is applied, you can install the wall surround. To do this, you'll need to start at the bottom of the wall and work your way up. As you install each piece of the wall surround, you'll need to make sure that it is level and that it is properly aligned with the other pieces.

5. Grout the Wall Surround

Once the wall surround is installed, you'll need to grout it. Grout is a type of mortar that is used to fill the gaps between tiles. To grout the wall surround, you'll need to mix the grout according to the manufacturer's instructions and then apply it to the gaps between the tiles using a grout float.

6. Caulk the Wall Surround

Once the grout is dry, you'll need to caulk the wall surround. Caulk is a type of sealant that is used to prevent water from leaking into the wall. To caulk the wall surround, you'll need to apply a bead of caulk to the joints between the wall surround and the bathtub, the wall surround and the ceiling, and the wall surround and the floor.

7. Install the Bathtub

The final step is to install the bathtub. To do this, you'll need to set the bathtub in place and then connect the plumbing and electrical connections. Once the bathtub is installed, you'll need to caulk the joint between the bathtub and the wall surround.