How To Replace A Clawfoot Bathtub Faucet

How to Replace a Clawfoot Bathtub Faucet

Replacing a clawfoot bathtub faucet is not a difficult task, but it does require a few specialized tools and materials. With careful planning and preparation, you can complete this project in a matter of hours.

Materials You Will Need:

New clawfoot bathtub faucet
Wrench
Adjustable wrench
Plumber's putty
Teflon tape
Screwdriver
Tape measure

Safety First:

Before you begin, be sure to turn off the water supply to your bathtub by closing the shutoff valves under the sink. Also, place a bucket or towel under the faucet to catch any water that may leak out during removal.

Step-by-Step Instructions:

Step 1: Remove the Old Faucet

Using a wrench and adjustable wrench, remove the nuts that hold the old faucet in place. Once the nuts are loose, carefully lift the faucet off the bathtub.

Step 2: Clean the Bathtub Surface

Remove any old plumber's putty or debris from the bathtub surface where the new faucet will be installed. A damp cloth and some mild dish soap should do the trick.

Step 3: Apply Plumber's Putty

Roll a small bead of plumber's putty into a snake shape and place it around the base of the new faucet. This will help create a watertight seal.

Step 4: Install the New Faucet

Carefully place the new faucet onto the bathtub, making sure that the plumber's putty is making good contact with the bathtub surface. Tighten the nuts by hand until they are snug.

Step 5: Tighten the Nuts

Use a wrench to tighten the nuts on the bottom of the faucet. Do not overtighten, as this can damage the faucet or the bathtub. Use an adjustable wrench to tighten the nuts on the side of the faucet.

Step 6: Apply Teflon Tape

Wrap a few layers of Teflon tape around the threads of the supply lines. This will help prevent leaks.

Step 7: Connect the Supply Lines

Connect the hot and cold supply lines to the corresponding valves on the faucet. Use a wrench to tighten the connections.

Step 8: Turn on the Water

Turn on the water supply to your bathtub and check for leaks. If you find any leaks, tighten the nuts or connections until the leak stops.

Step 9: Enjoy Your New Faucet

Your new clawfoot bathtub faucet is now installed and ready to use. Enjoy its beautiful design and improved functionality.