How To Remove And Install Bathtub Faucet

How to Remove and Install a Bathtub Faucet

Replacing a bathtub faucet is a relatively simple plumbing project that can be completed in a few hours with the right tools and materials. Here's a step-by-step guide to help you remove and install a bathtub faucet.

Tools and Materials You'll Need:

Adjustable wrench
Plumbers putty
Teflon tape
New bathtub faucet

Step 1: Turn Off the Water Supply

Before starting, turn off the water supply to the bathtub by closing the shut-off valves located under the sink or behind the access panel.

Step 2: Remove the Old Faucet

Use the adjustable wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, carefully pull the faucet out of the tub.

Step 3: Clean the Faucet Seat

Use a rag or sponge to clean the faucet seat where the new faucet will be installed. Remove any old plumbers putty or debris.

Step 4: Apply Plumbers Putty to the New Faucet

Roll a small amount of plumbers putty into a rope and place it around the base of the new faucet. This will help create a watertight seal.

Step 5: Wrap Teflon Tape Around the Threads

Wrap Teflon tape clockwise around the threads of the faucet's mounting posts. This will prevent water leaks.

Step 6: Install the New Faucet

Align the new faucet with the mounting holes and carefully insert it into the tub. Tighten the nuts by hand as much as possible.

Step 7: Use an Adjustable Wrench to Tighten the Nuts

Use the adjustable wrench to further tighten the nuts. Be careful not to overtighten, as this could damage the faucet or the tub.

Step 8: Turn on the Water Supply

Turn the water supply back on and check for leaks. If there are any leaks, tighten the nuts further or add more plumbers putty to the base of the faucet.