Replace Bathtub Drain Lever

Replace Bathtub Drain Lever: A Step-by-Step Guide

A bathtub drain lever is a small but important part of your bathroom. It controls the flow of water out of the tub and can become worn or damaged over time. If your drain lever is not working properly, it can lead to leaks or other problems. Replacing a bathtub drain lever is a relatively simple task that can be completed in a few minutes.

Tools and Materials

To replace a bathtub drain lever, you will need the following tools and materials:

Phillips head screwdriver
New bathtub drain lever
Plumber's putty

Instructions

Follow these steps to replace a bathtub drain lever:

Turn off the water supply to the bathtub. This is usually done by turning off the valve under the sink.
Remove the old drain lever. Using a Phillips head screwdriver, remove the screws that hold the drain lever in place. Once the screws are removed, pull the drain lever straight up to remove it.
Apply plumber's putty to the new drain lever. Roll a small piece of plumber's putty into a ball and place it on the threads of the new drain lever. This will help to create a seal and prevent leaks.
Install the new drain lever. Insert the new drain lever into the hole in the bathtub and tighten the screws to secure it.
Turn on the water supply to the bathtub and check for leaks. Open the faucet and check for any leaks around the drain lever. If there are any leaks, tighten the screws further.

Tips

Here are a few tips for replacing a bathtub drain lever:

Be careful not to overtighten the screws when installing the new drain lever. This can damage the drain lever or the bathtub.
If you are not comfortable replacing the drain lever yourself, you can call a plumber for assistance.
Replacing a bathtub drain lever is a relatively simple task that can be completed in a few minutes. By following these steps, you can save yourself the cost of hiring a plumber.