Old Kohler Bathtub Drain Stopper

Unclogging and Replacing Your Old Kohler Bathtub Drain Stopper

The bathtub is a place to relax and rejuvenate. A faulty drain stopper can turn your peaceful bathing experience into a frustrating one. If you have an old Kohler bathtub drain stopper that's giving you trouble, don't worry - you can easily unclog or replace it yourself. ### Unclogging Your Drain Stopper If your drain stopper is simply clogged with hair and soap scum, you can usually unclog it without removing it. Here are a few methods you can try: 1.

Use a Zip Tie:

Straighten out a wire zip tie and insert it into the drain hole. Move it around to loosen the clog. Once the clog is broken up, flush the drain with hot water. 2.

Use a Baking Soda and Vinegar Solution:

Pour a cup of baking soda down the drain, followed by a cup of vinegar. Let it sit for 30 minutes, then flush the drain with hot water. This solution will help to dissolve hair and soap scum. 3.

Use a Commercial Drain Cleaner:

If the above methods don't work, you can try using a commercial drain cleaner. Be sure to follow the instructions on the product label carefully. ### Replacing Your Drain Stopper If your drain stopper is cracked or damaged, you'll need to replace it. Here are the steps involved: 1.

Turn Off the Water Supply:

Before you start, turn off the water supply to your bathtub. You can do this by closing the valve under the sink or by turning off the main water supply to your home. 2.

Remove the Old Drain Stopper:

Most drain stoppers are held in place by a few screws. Use a screwdriver to remove the screws, then pull the drain stopper out of the drain hole. 3.

Clean the Drain Hole:

Once the drain stopper is removed, take a few minutes to clean the drain hole. You can use a bottle brush or a drain snake to remove any remaining hair or soap scum. 4.

Install the New Drain Stopper:

Place the new drain stopper in the drain hole and tighten the screws. Be sure to tighten the screws snugly, but don't overtighten them. 5.

Turn On the Water Supply:

Once the new drain stopper is installed, turn on the water supply and check for leaks. If there are no leaks, you're good to go! ### Conclusion Replacing or unclogging a Kohler bathtub drain stopper is a relatively easy task that you can do yourself in a few minutes and at little cost. You may need a few simple tools and purchase a new drain stopper if needed. If you're having trouble with your drain stopper, don't hesitate to give these methods a try. With a little effort, you can have your bathtub draining properly again in no time.